Badges for 3DMaxPider mats in Tesla Model S, 3 and X.
One:(Special Cases) Two:(Set: Driver/Passenger or Trunk/Frunk) Four:(Full Set: Driver, Passenger, Trunk & Frunk) These are screw attached. These are shipped in batches.
Recommendations: To waterproof/minor adhesion use this or similar https://www.amazon.com/Permatex-80050-Silicone-Adhesive-Sealant/dp/B0002UEPVI/ "Permatex 80050 Silicone Adhesive Sealant" Make sure you do not put pin through existing hole as it'll be loose, but pin is offset from hole so won't be a problem. In front mats an indent is there but it does fill in a bit. Instructions: Pry the buttons off of the back of the old mats. (Use flathead screwdriver or pry tool). If using silicone(Highly recommend) clean area with alcohol and a paper towel or cloth, let dry for a minute. Apply silicone to the existing holes(be a little generous) and then align the pin and press until it's fully into mat. If any silicone comes out wipe away with wet towel or latex glove Done! Please verify your address! Once it's marked delivered it's out of my hands and will be between you and the courier.